NEC Univerge SV8100 - Page 1126

Issue 1.0 UNIVERGE SV8100
2 - 1102 TAPI Compatibility
Operation
TAPI operation is automatic once programmed in the telephone system and enabled in the PC TAPI
application, unless a headset is used.
Using the Headset with Automatic Answer:
1. With the multiline terminal in an idle state, press the Help key.
2. Press the Headset key (Program 15-07 or SC 751: 05) twice.
3. Press the Exit key to return the display to idle.
 The Headset key blinks when Automatic Headset is activated.
 To cancel Automatic Headset, repeat these steps.
To redirect calls to the headset and disable the hookswitch (required for some TAPI features):
1. With the multiline terminal in an idle state, press the Help key.
2. Press the Headset key (Program 15-07 or SC 751: 05) twice.
3. Press the Exit key to return the display to idle.
 The Headset key blinks when Automatic Headset is activated.
 To cancel Automatic Headset, repeat these steps.
4. Press the Headset key (Program 15-07 or SC 751: 05) to go Off-Hook.
10-12-03 CD-CP00-AU Network Setup –
Default Gateway
Assign the default gateway IP
address for the CD-CP00-AU.
0.0.0.0 ~
126.255.255.254
128.0.0.1 ~
191.254.255.254
192.0.0.1 ~
223.255.255.254
(default = 0.0.0.0)
3
10-20-01 LAN Setup for External
Equipment – TCP Port
Use to define the TCP port/
address/etc. for communicating to
external equipment.
0~65535
default:
External Device 1 (CTI)
= 0
External Device 2 (ACD
MIS) = 4000
External Device 5
(SMDR Output) = 0
External Device 6 (DIM
Output) = 0
External Device 11
(O&M Server) = 8010
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3