NEC Univerge SV8100 - Page 1133

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1109
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
 Level 1 – these are the most commonly assigned programs for this feature.
 Level 2 – these are the next most commonly assigned programs for this feature.
 Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
10-20-01 LAN Setup for External
Equipment - TCP Port
Define a TCP port against External
Device 12 for Traffic Report Output.
0~65536
(default = not assigned)
90-20-01 Traffic Report Data Setup – Call
Traffic Output
Determine whether or not the Call
Traffic Output should be measured.
0 = Not Measured
1 = Measure
(default = 0)
3
90-20-03 Traffic Report Data Setup – All
Line Busy Output
All Line Busy Output. 0 = Not Detected
1~256
(Report when the data
reaches the defined
value)
(default = 0)
3
90-20-04 Traffic Report Data Setup – DTMF
Receiver Busy Output
Use to define the DTMF receiver
busy output details of the traffic
report.
0 = Not Detected
1~256
(Report when the data
reaches the defined
value)
(default = 0)
3
90-20-05 Traffic Report Data Setup – Dial
Tone Detector Busy Output
Use to define the dial tone detector
busy output details of the traffic
report.
0 = Not Detected
1~256
(Report when the data
reaches the defined
value)
(default = 0)
3
90-20-06 Traffic Report Data Setup – Caller
ID Receiver Busy Output
Use to define the caller ID receiver
busy output details of the traffic
report.
0 = Not Detected
1~256
(Report when the data
reaches the defined
value)
(default = 0)
3
90-20-07 Traffic Report Data Setup – Voice
Mail Channel All Busy Output
Use to define the voice mail
channel all busy output details of
the traffic report.
0 = Not Detected
1~256
(Report when the data
reaches the defined
value)
(default = 0)
3