Issue 1.0 UNIVERGE SV8100
2 - 1120 Transfer
25-06-01 VRS/DISA One-Digit Code
Attendant Setup – Next Attendant
Message Number
Set up single digit dialing through
the VRS. This gives VRS callers
single-key access to extensions,
the company operator, Department
Calling Groups and Voice Mail. For
each VRS message set to answer
outside calls (see Program 25-02
and Program 25-05), you specify:
The digit the VRS caller dials
(0~9, ,
#). (Keep in mind that if
you assign destinations to digits,
outside callers cannot dial
system extensions, starting with
that digit.
The destination reached (eight
digits maximum) when the caller
dials the specified digit.
The destination can be an
extension, a Department Calling
pilot number or the Voice Mail
master number. A one-digit code
can be assigned for each
Automated Attendant message.
0~100 (0 = No Setting)
101 = Voice MAil
Answers
104 = Refer to 25-04:
VRS/DISA Transfer
Ring Group with No
Answer/ Busy
105 = Dial the other
extension
(default = 0)
3
25-06-02 VRS/DISA One-Digit Code
Attendant Setup – Destination
Number
Define the digit to be used by a
VRS caller which allows their call to
be transferred to the external page.
Up to eight digits
(default not assigned)
3
31-05-01 Universal Night Answer/Ring
Over Page
For each trunk which should ring
the external page, set the External
Page zone (1~9) to allow ringing
(1).
0 = No Ringing (No)
1 = Ringing (Yes)
(default = 0)
3
81-10-07 COI Initial Data Setup – Hookflash
Time Selection 1
Set the flash duration for analog
trunk calls (1~255 in 16 ms steps).
0 = 20 ms
1 = 40 ms
2 = 60 ms
3 = 80 ms
4 = 100 ms
5 = 140 ms
6 = 160 ms
7 = 200 ms
8 = 400 ms
9 = 600 ms
10 = 800 ms
11 = 1.0 seconds
12 = 1.5 seconds
13 = 2.0 seconds
14 = 3.0 seconds
15 = 5.0 seconds
[default = 4 (100ms)
All Trunks]
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
