NEC Univerge SV8100 - Page 1174

Issue 1.0 UNIVERGE SV8100
2 - 1150 UCB (Unified Communications for Business)
10-20-01 LAN Setup for External
Equipment – TCP Port
Define the TCP port (0~65535)
when communicating to the CTI
server (type 1).
0~65535
default:
External Device 1 (CTI
Server) = 0
External Device 2 (ACD
MIS) = 4000
External Device 5
(SMDR Output) = 0
External Device 6 (DIM
Output) = 0
External Device 11
(O&M Server) = 8010
3
11-07-01 Department Group Pilot Numbers
– Dial
Assign a Department Group pilot
number for the Voice Mail (eight
digits maximum). The extensions
are assigned to the group in
Program 16-02-01.
Up to eight digits
(default not assigned)
3
15-03-03 Single Line Telephone Basic Data
Setup – Terminal Type
Enter 1 for this option to allow a
single line port to receive DTMF
tones after the initial call setup.
Enter 0 to have the port ignore
DTMF tones after the initial call
setup. For Voice Mail, always enter
1 (e.g., receive DTMF tones).
0 = Normal
1 = Special
(default = 0)
3
15-05-18 IP Telephone Terminal Basic Data
Setup – IP Duplication Allowed
Group
If there is an adapter that has one
IP address coming into it but has
multiple extensions off of it. Assign
all the extensions to a group so that
way the CPU knows that the one IP
address is assigned to multiple
extensions.
0 = Not Used
1 = Group 1
2 = Group 2
3 = Group 3
4 = Group 4
5 = Group 5
6 = Group 6
7 = Group 7
8 = Group 8
9 = Group 9
10 = Group 10
(default = 0)
3
16-01-01 Department Group Basic Data
Setup – Department Name
Assign a name to the Extension
(Department) Groups.
Maximum 12 characters
(default not assigned)
3
16-01-03 Department Group Basic Data
Setup – Department Routing
When Busy (Auto Step Call)
Set how the system routes an
Intercom call to a busy Department
Group member. The caller can
hear busy tone (0) or overflow to
the first available Department
Group member (1). This option is
for Intercom calls to an extension,
not a pilot number.
0 = Normal (Intercom
caller to busy
department member
hears busy)
1 = Circular (Intercom
callers to busy
department member
routes to idle member)
(default = 0)
3
16-01-09 Department Group Basic Data
Setup – Department Hunting No
Answer Time
Set how long a call rings a
Department Group extension
before hunting occurs.
64800 (seconds)
(default = 15 seconds)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3