NEC Univerge SV8100 - Page 1193

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1169
45-01-05 Voice Mail Integration Options –
Message Wait
When using Centrex transfer from a
voice mail port then the following
items must be considered:
 If the Feature Access Code
starts with
# in Program
11-12-42 then set Program
45-01-05 to “Off”.
 When assigning the dial string in
voice mail, one or more
“Pauses” may be needed too,
depending on what Telco
needs.
0 = Off
1 = On
(default = 1)
3
45-01-06 Voice Mail Integration Options –
Record Alert Tone Interval Time
This timer sets the interval
(0~64800 seconds) between Voice
Mail Conversation Record alerts.
0~64800 (seconds)
(default = 30)
3
45-01-18 Voice Mail Integration Options –
Trunk Number Mapping
Assign the digits of trunk number
mapping.
Options
2~3
(default = 2)
3
80-01-02 Service Tone Setup – Basic Tone
Number
Used to customize the systems
service tones.
1~33
0 = No Tone
33 = Default Time Slot
(refer to the SV8100
Programming Manual
for default values)
3
80-03-01 DTMF Tone Receiver Setup –
Detect Level
Used to customize the Detect Level
for DTMF Tone Receivers.
0 = 0dBm ~ -25dBm
1 = -5dBm ~ -30dBm
2 = -10dBm ~ -35dBm
3 = -15dBm ~ -40dBm
4 = -20dBm ~ -45dBm
5 = -25dBm ~ -50dBm
6 = -30dBm ~ -55dBm
default: 0 Type 1~5
3
80-03-02 DTMF Tone Receiver Setup –
Start delay time
Use this option to define the start
delay time for DTMF Tone
Receiver.
0~255
(0.25 ms ~ 64 ms)
default:
Type 1~5 = 0
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3