NEC Univerge SV8100 - Page 1192

Issue 1.0 UNIVERGE SV8100
2 - 1168 UM8000 Mail
For Either Method:
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-12-42 Service Code Setup (for Service
Access) – Flash on Trunk Lines
Program the dial access code to
use for sending a hook flash to
Telco. This code is used for
Centrex Transfer using Digital
Voice Mail ports. If this code starts
with
#, Program 45-01-05 must be
set to 0 (Off).
SLT
(default =
#3)
3
22-04-01 Incoming Extension Ring Group
Assignment
To enable Voice Mail Overflow,
assign selected extensions to a
Ring Group that ring for
unanswered DILs to Voice Mail
ports. In Program 22-06, enter 1 to
enable overflow ringing.
Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring for
incoming Ring Group 1
calls. No other
extensions ring for
incoming Ring Group 1
calls.
3
22-08-01 DIL/IRG No Answer Destination For Voice Mail Overflow, enter the
Ring Group that unanswered DILs
to Voice Mail ring after the DIL Call
Waiting time (Program 22-01-04).
0 (No Setting)
001~100
(Incoming Ring Group)
102 (In-Skin/
External Voice Mail
or VM8000 InMail)
(default = 1)
3
24-02-03 System Options for Transfer –
Delayed Call Forwarding Time
Set the interval a transferred call
waits at a forwarded extension
before routing to the called
extension mailbox.
0~64800 (seconds)
(default = 10)
3
45-01-01 Voice Mail Integration Options –
Voice Mail Department Group
Number
Assign which Extension
(Department) Group number is to
be assigned as the voice mail
group. This program defines the
Quick Transfer to Voice Mail
destination. An entry of ‘0’ means
there is no voice mail installed.
Department Groups: 0, 1~64
0~64
0 = No Voice Mail
(default = 0)
3
45-01-02 Voice Mail Integration Options –
Voice Mail Master Name
Enter the Voice Mail master name
up to 12 characters.
Up to 12 Characters
(default = Voice Mail)
3
45-01-04 Voice Mail Integration Options –
Park and Page
Enable (1) or disable (0) the system
ability to process the Voice Mail
Park and Page () commands. You
should normally enable this option.
0 = Off
1 = On
(default = 1)
3