Issue 1.0 UNIVERGE SV8100
2 - 1196 UNIVERGE Multimedia Conference Bridge
11-07-01 Department Group Pilot Numbers
– Dial
Assign a Department Group pilot
number for the CNF(8)-U ETU
(eight digits max). The extensions
are assigned to the group in
Program 16-02-01.
Up to eight digits
(default not assigned)
3
15-03-01 Single Line Telephone Basic Data
Setup – SLT Signaling Type
For each SLT extension, this option
must be set to 0.
0 = DP
1 = DTMF
(default = 1)
3
15-03-03 Single Line Telephone Basic Data
Setup – Terminal Type
Enter 1 for this option to allow a
single line port to receive DTMF
tones after the initial call setup.
Enter 0 to have the port ignore
DTMF tones after the initial call
setup. For Voice Mail, always enter
1 (e.g., receive DTMF tones).
0 = Normal
1 = Special
(default = 0)
3
16-01-01 Department Group Basic Data
Setup – Department Name
Assign a name to the Extension
(Department) Groups.
Maximum 12 characters
(default not assigned)
3
16-01-02 Department Group Basic Data
Setup – Department Calling Cycle
Set the routing cycle for calls into a
department (i.e., when a user dials
the department pilot number). The
system can ring the highest priority
extension available (Priority
Routing, 0) or cycle in circular order
to a new idle extension for each
new call (Circular Routing, 1).
0 = Normal Routing
(Priority)
1 = Easy – UCD
Routing (Circular)
(default = 0)
3
16-01-03 Department Group Basic Data
Setup – Department Routing
When Busy (Auto Step Call)
Set how the system routes an
Intercom call to a busy Department
Group member. The caller can
hear busy tone (0) or overflow to
the first available Department
Group member (1). This option is
for Intercom calls to an extension,
not a pilot number.
0 = Normal (Intercom
caller to busy
department member
hears busy)
1 = Circular (Intercom
callers to busy
department member
routes to idle member)
(default = 0)
3
16-01-04 Department Group Basic Data
Setup – Hunting Mode
Set if an unanswered call should
hunt once stopping at the last
member tried (0) or continually hunt
through the idle members (1).
0 = Last extension is
called and hunting is
stopped
1 = Circular
(default = 0)
3
16-01-05 Department Group Basic Data
Setup – Extension Group All Ring
Mode Operation
Set if all members of the group
should ring automatically (1) or
through the use of the service code
(0) defined in Program 11-12-09.
Selecting automatic will override
the settings of Programs 16-01-03
and 16-01-04.
0 = Manual
1 = Automatic
(default = 0)
3
16-01-06 Department Group Basic Data
Setup – STG Withdraw Mode
Use to set the STG withdraw mode
for each department group.
0 = Disable (Camp On)
1 = Enable (Overflow
Mode)
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
