NEC Univerge SV8100 - Page 1221

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1197
16-01-07 Department Group Basic Data
Setup – Call Recall Restriction for
STG
Determine whether or not an
unanswered call transferred to a
Department Group should recall the
extension from which it was
transferred.
0 = Disable (Recall)
1 = Enable (No Recall)
(default = 0)
3
16-01-09 Department Group Basic Data
Setup – Department Hunting No
Answer Time
Set how long a call rings a
Department Group extension
before hunting occurs.
64800 (seconds)
(default = 15 seconds)
3
16-01-10 Department Group Basic Data
Setup – Enhanced Hunt Type
Set the type of hunting for each
Extension (Department) Group.
0 = No queuing
1 = Hunting When Busy
2 = Hunting When Not
Answered
3 = Hunting When Busy
or No Answer
(default = 0)
3
16-02-01 Department Group Assignment
for Extensions
Set up the Department Group
called by the pilot number and the
extension priority when a group is
called.
Call Pickup Groups are set up in
23-02.
Department Groups
1-64
Priority 1-512
Default = All extensions
in Department Group 1
with priority in port
order:
Port 1 priority = 1
Port 512 priority = 512
3
20-13-13 Class of Service Options
(Supplementary Service) –
Continued Dialing (DTMF) Signal
on ICM Call
Turns Off (0) or On (1) an extension
user ability to use Continued
Dialing, which allows DTMF signal
sending while talking on extension.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
22-02-01 Incoming Call Trunk Setup Assign Service Type 4 to each
trunk you want to ring into the
Multimedia Conference Bridge as a
Direct Inward Line (DIL).
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
3
22-07-01 DIL Assignment Assign the master/pilot number of
the Conference group from
Program 11-07-01 as the DIL
destination. If all Conference ports
are in the same unique Extension
(Department) Group (see Program
16-02 above), the DIL will ring
another Conference port if its
assigned port is busy.
Extension Number
(maximum eight digits)
(default not assigned)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3