UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 101
26-01-07 Automatic Route Selection
Service – F-Route Access COS
Reference
Use this program to define the
system options for Automatic Route
Selection (ARS).
0 = F-Route
1 = ARS
(default = 0)
3
26-02-01 Dial Analysis Table for ARS/LCR –
Dial
Enter the digits (16 digits maximum:
1~9, 0
#, @; 400 separate entries)
for the Dial Analysis Table which is
analyzed by ARS/LCR. This table is
checked after any programmed
F-Route operations have completed.
The system then refers to Program
26-02-02 and Program 26-02-03 to
determine the routing for the call. To
enter a wild card/don’t care digit,
press Line Key 1 to enter an @
symbol. It is important to remember
that the system checks the table
numbers in numerical order. This
means that entries for specific
numbers should be entered first
(such as your local area codes), then
enter the items containing wild card
digits. If the system sees an entry of
2@@, any table entries which follow
are ignored.
For example, if 268, 269, and 270
are local exchanges, these would be
the first three table entries which
route according to the settings made
in Program 26-02-02 and Program
26-02-03 for each of the table
entries. If the next entry is 2@@, the
system checks no further in this
program and routes all other 2xx
numbers according to the entries
made in Program 26-02-02 and
Program 26-02-03 for this table
entry.
Dial Digits
(16 digits maximum)
1~9, 0,
, #, or for wild
character (Press line
key 1)
(default not assigned)
3
26-02-02 Dial Analysis Table for ARS – ARS
Service Type
For each Dial Analysis Table
(1~200), select 0 for no ARS, 1 for
Service Type 1 – Route to Trunk
Group Number to have the number
route to a trunk group [Refer to
Program 26-02-03] or 2 for Service
Type 2 – F-Route Selected to have
the dialed number controlled by the
F-Route table. If Service Type 2 is
selected and F-Route operation is
on, the F-Route table used is
determined by Program 44-04. If F-
Route operation is off, the routing is
determined by Program 44-05.
0 = No Service (None)
1 = Route to Trunk
Group
2 = Select F-Route
Access
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
