NEC Univerge SV8100 - Page 126

Issue 1.0 UNIVERGE SV8100
2 - 102 Automatic Route Selection
26-02-03 Dial Analysis Table for ARS –
Additional Data/Service Number
For each Dial Analysis Table
(1~200), if Service Type 1 was
selected in Program 26-02-02, enter
the trunk group number (0~100,
0 = No Route).
If Service Type 1 (in
26-02):
Select Trunk Group
Number
(0~100, 0 = No Route)
If Service Type 2 (in
26-02):
F-Route Time Schedule
Not Used = 0~500
(F-Route Table
Number).
Refer to Program 44-05:
ARS/F-Route Table
F-Route Time Schedule
Used = 0~500 (F-Route
Selection Number).
Refer to Program 44-04:
ARS/F-Route Selection
for Time Schedule.
(default = 0)
3
26-02-04 Dial Analysis Table for ARS – ARS
Class of Service
For each Dial Analysis Table
(1~200), set the Automatic Route
Selection (ARS) Class of Service
(0~16).
0~16
(default = 0)
3
26-02-05 Dial Analysis Table for ARS – Dial
Treatment for ARS
For each Dial Analysis Table
(1~200), set the Automatic Route
Selection (ARS) Dial Treatment
(0~15) to be used.
0~15
(default = 0)
3
26-02-07 Dial Analysis Table for ARS –
Network Specified Parameter
Table
For each Dial Analysis Table
(1~200), set the Automatic Route
Selection (ARS) Network Specified
Parameter Table (0~16) to be used.
0~16
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3