NEC Univerge SV8100 - Page 1286

Issue 1.0 UNIVERGE SV8100
2 - 1262 Voice Mail Integration (Analog)
20-13-07 Class of Service Options
(Supplementary Service) –
Message Waiting
Turns Off (0) or On (1) an extension
ability to leave Message Waiting.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-12 Class of Service Options
(Supplementary Service) – Room
Monitor, Extension Being
Monitored
Turns Off (0) or On (1) an extension
ability to be monitored.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-13-13 Class of Service Options
(Supplementary Service) –
Continued Dialing (DTMF) Signal
on ICM Call
Turns Off (0) or On (1) an extension
user ability to use Continued
Dialing, which allows DTMF signal
sending while talking on extension.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-16 Class of Service Options
(Supplementary Service) – Barge-
In, Receive
In an extension Class of Service,
turns On (1) or Off (0) Barge-In at
the receiving extension (i.e., Barge-
In receive).
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-13-28 Class of Service Options
(Supplementary Service) – Allow
Class of Service to be Changed
Turns Off or On the ability of an
extension COS to be changed via
Service Code 677.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-13-35 Class of Service Options
(Supplementary Service) – Block
Camp On
Use this option to Turns On (1) or
Off (0) extension ability to block
callers from dialing
# to camp-on.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
22-02-01 Incoming Call Trunk Setup –
Incoming Type
Used to assign the incoming trunk
type for each trunk. There is one
item for each Mode. When using
Trunk-to-Trunk Forwarding the
trunks must be set for Normal (0).
0 = Normal
1 = VRS (second dial
tone if no VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
3
22-04-01 Incoming Extension Ring Group
Assignment
Use this program to assign
extensions (up to 32) to Ring
Groups. Calls ring extensions
according to Ring Group
programming.
Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring for
incoming Ring Group 1
calls. No other
extensions ring for
incoming Ring Group 1
calls.
3
22-07-01 DIL Assignment Assign the destination extension for
each DIL incoming trunk
(001~200).
 For this selection to work, set
Program 22-02-01 to 4 = DIL.
Extension Number
(maximum eight digits)
(default not assigned)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3