NEC Univerge SV8100 - Page 1295

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1271
Operation
Calling your Mailbox
To call your mailbox:
Multiline Terminal
1. Press your Voice Mail key (Program 15-07 or SC 751: 77) or the Message key.
- OR -
Press Speaker and dial the Voice Mail Master Number. After Voice Mail Answers, dial your mailbox
number.
 Your mailbox number is normally the same as your extension number. You may optionally dial a co-worker’s
mailbox - or use this procedure to call your mailbox from a co-worker’s telephone.
- OR -
Press Speaker and dial 8.
2. If requested by Voice Mail, enter your security code.
 Ask your Voice Mail system administrator for your security code.
 Normally, your Message Waiting LED goes out (if applicable). If it continues to flash, you have unanswered
Message Waiting requests or a new General Message. Refer to Checking Messages on page 2-1247.
Single Line Telephone
1. Lift the handset and dial 8.
 If you are at a co-worker’s telephone, you can dial the Voice Mail master number and your mailbox number
instead. You can also use this procedure from your own telephone to call a co-worker’s mailbox.
2. If requested by Voice Mail, enter your security code.
Checking Messages
1. Press the Message key once.
 The voice mail is called.
 When there are new messages, the Large LED on the telephone flashes as red.
 With this option set, the MSG key can be used as a Voice Mail key for any function [calling voice mail or transfer
call a to voice mail (Hold + MSG + Extension Number), etc.].