NEC Univerge SV8100 - Page 1337

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 1313
84-19-27 SIP Extension CODEC
Information Basic Setup – RX
Gain
Use this program to define to RX
Gain Values – Adjusting this value
increases or decreases volume levels
for the sending party. Consult the
UNIVERGE SV8100 Programming
Manual for Transmit Gain scale to set
acceptable value.
0~40 =
(-20dbm ~ +20dbm)
0 =-20 dbm
1 =-19 dbm
:
20 =0 dbm
:
39 =+19 dbm
40 =+20 dbm
(default = 20)
3
84-19-28 SIP Extension CODEC
Information Basic Setup – Audio
Capability Priority
Use this program to define to. Consult
the UNIVERGE SV8100
Programming Manual for Transmit
Gain scale to set acceptable value.
0 = G.711_PT
1 = G.723_PT
2 = G.729_PT
3 = G.722
4 = G.726
5 = Not Used
(default = 0)
3
84-19-31 SIP Extension CODEC
Information Basic Setup – DTMF
Payload Number
Use this program to define the DTMF
Payload Number.
96~127
(default = 96)
3
84-19-32 SIP Extension IP CODEC
Information Basic Setup – DTMF
Relay Mode
Use this program to define the DTMF
Relay Mode.
0 = Disable
1 = RFC2833
(default = 0)
3
84-19-33 SIP Extension IP CODEC
Information Basic Setup –
Number of G.722 Audio Frames
Use this program to define the
number of Audio Frames for G.722
CODEC.
1~4
1 = 10 ms
2 = 20 ms
3 = 30 ms
4 = 40 ms
(default = 3)
3
84-19-34 SIP Extension IP CODEC
Information Basic Setup – G.722
Voice Activity Detection Mode
Use the program to define the G.722
Voice Activity Detection Mode.
0 = Disabled
1 = Enabled
(default = 0)
3
84-19-35 SIP Extension IP CODEC
Information Basic Setup – G.722
Jitter Buffer (min)
Use this program to define the
minimum setting for the G.722 Jitter
Buffer.
0~160 ms
(default = 30)
3
84-19-36 SIP Extension IP CODEC
Information Basic Setup – G.722
Jitter Buffer (Average)
Use this program to define the
average setting for the G.722 Jitter
Buffer.
0~160 ms
(default = 60)
3
84-19-37 SIP Extension IP CODEC
Information Basic Setup – G.722
Jitter Buffer (Max)
Use this program to define the
maximum setting for the G.722 Jitter
Buffer.
0~160 ms
(default = 120)
3
84-19-38 SIP Extension IP CODEC
Information Basic Setup –
Number of G.726 Audio Frames
Use this program to define the
number of G.726 Audio Frames.
1~4
1 = 10 ms
2 = 20 ms
3 = 30 ms
4 = 40 ms
(default = 3)
3
84-19-39 SIP Extension IP CODEC
Information Basic Setup – G.726
Voice Activity Detection Mode
Use this program to define the G.726
Voice Activity Detection Mode.
0 = Disabled
1 = Enabled
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3