NEC Univerge SV8100 - Page 1367

UNIVERGE SV8100 Issue 1.0
Codes Tables 3 - 27
Do Not Disturb Code: 03
Operation: Press key
+ code (0~4)
Setting your telephone in
DND
DND key on red 747
Do Not Disturb/Call
Forward Override
Code: 37
Operation: Press key
Calling an extension which
is in DND or Call
Forwarded
None -
General Purpose
Relay
Code: 51 + relay
number
Operation: Press key
Activating the general
purpose relay
On when active 780
Group Call Pickup Code: 24
Operation: Speaker
key +
Press key
Answering a call ringing
another telephone in your
Pickup Group
None
#
Code: 25
Operation: Speaker
key +
Press key
Answering a call ringing a
telephone in another
Pickup Group – if you do
not know the group
number
None 769
Code: 26 + Pickup
Group (1~8 or 1~9 or
01~64)
Operation: Speaker
key + Press key +
Pkup Group
Answering a call ringing a
telephone in a specific
Pickup Group
None 768
Handset Cutoff Code: 40
Operation: Press key
Cutting off the handset
transmission while on a
call
On when feature
active (no
transmission on
handset)
-
Hotline Code: 01 + dest. ext
Operation: Press key
Placing a call to your
Hotline partner
Full BLF (red) for
covered ext.
-
Headset Operation Code: 05
Operation: Press key
Enabling or disabling
Headset Operation
On red when
activated
688
Hold Code: 44
Operation: Place or
answer call + Press
key
Putting a call on System
Hold (if your telephone’s
Hold key is reassigned)
None -
Code: 45
Operation: Place or
answer call + Press
key
Putting a call on Exclusive
Hold
None -
To program a key, press Speaker, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
press the key and enter the code (e.g., 48 for Voice Over).
For this feature... Use this key... When your are... Key Lamp Status
Also See
Srvc Code