NEC Univerge SV8100 - Page 1368

Issue 1.0 UNIVERGE SV8100
3 - 28 Codes Tables
Meet Me
Conference
(Also see
Conference)
Code: 32
Operation: Press key
Joining a Meet Me
Conference
None 763 or 764
Memo Dial Code: 31
Operation:
Store
: While on call,
press key + number to
store
Use
: Press Key + Call
or line
Erase
: Speaker key +
Press key
Storing, using or checking
a Memo dial number
None -
Message Waiting Code: 38
Operation: Leave
message: Call ext +
Press key OR Answer
message: Press key
Answering/Leaving a
Message Waiting
None
0
Microphone Cutoff Code: 02
Operation: Set up call
+ Press key
Using Microphone Cutoff On red when
activated
-
Call Arrival (CAR)
Keys
Code:
03 + ext. or
dept group
Operation: Press key
Placing or answering a
call to your virtual
(phantom)
extension
Slow Flash red
when ringing, On
red when busy
-
Name Storing Code: 55
Operation: Press key
+ ext ## + name + Hold
Entering a name for the
extension to be displayed
on telephones
None 700
Networking Code:
06 + network
(01~50)
Operation: Press key
Accessing a networked
trunk
None -
Night Service Code: 09 + mode (1~4
or 1~8)
Operation: Press key
Activating the Day/Night
Mode
On red when
activated
718 +
+ 0
Off-Hook Signaling Code: 33
Operation: Call ext.
and receive busy +
Press key
Signaling a busy
extension
None 7
Paging, External Code: 19 + zone (1~8)
Operation: Press Key
Making an external zone
page
On red when
activated
703 + zone
Code: 20
Operation: Press key
Making an external All Call
page
On red when
activated
703 + 0
To program a key, press Speaker, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
press the key and enter the code (e.g., 48 for Voice Over).
For this feature... Use this key... When your are... Key Lamp Status
Also See
Srvc Code