UNIVERGE SV8100 Issue 1.0
Codes Tables 3 - 31
To program a key, press Speaker, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
press the key and enter the code (e.g., 48 for Voice Over).
Use this key... For this feature... When you are... Key Lamp Status
Also see
Srvc Code
Code: 01 + dest.
ext. or outside tel # +
Hold
Operation: Press
key
Direct Station
Selection,
Hotline, One-Touch
Calling
Calling an extension or
outside number using a
DSS key
Off = extension
idle
On = extension
busy
Flashing = DND
747
Code: 02
Operation: Set up
call + Press key
Microphone Cutoff Using Microphone Cutoff On red when
activated
-
Code: 03
Operation: Press
key
Do Not Disturb Activating DND On red when
activated
-
Code: 04
Operation: Press
key
Background Music Turning BGM on or off On red when
activated
725
Code: 05
Operation: Press
key
Headset Operation Enabling or disabling
Headset Operation
On red when
activated
734
Code: 06
Operation:
Establish call + Hold
+ Ext + Press key
Transfer Transferring a call None -
Code: 07
Operation: Set up
call + Press key +
set up call to add +
Press key twice
Conference Setting up a conference or
a Meet Me Conference
On red during
setup
#1
Code: 08
Operation: Press
key
Incoming Caller ID List List incoming caller ID to
extension
Flashing when
new log created
On in call log
-
Code: 09 + mode
(1~4 or 1~8)
Operation: Press
key
Night Service Activating the D
ay/Night
Mode
On red when
activated
718 + mode
(1~4 or
1~8)
Code: 10
Operation: Press
key + Dest. Ext.
Call Forwarding,
Immediate
Call Forwarding to
extension or Voice Mail
Slowly flashes red 741
Code: 11
Operation: Press
key + Dest. Ext.
Call Forwarding,
Busy
Call Forwarding to
extension or Voice Mail
Slowly flashes red 742
To Next Page
Loading...
