NEC Univerge SV8100 - Page 1370

Issue 1.0 UNIVERGE SV8100
3 - 30 Codes Tables
Transfer Code: 06
Operation: Establish
call + Hold + Ext +
Press key
Transferring a call None -
Trunk Group
Routing
Code:
05
Operation: Press key
Accessing a trunk using
Trunk Group Routing
On red when
active
9
Trunk Groups Code:
02 + TRK
group (1~9 or
001~200)
Operation: Press key
Using a trunk group key to
access a Trunk Group
On red when
active
704
Trunk Queuing Code: 35
Operation: Hear busy
tone for Trk + Press
key
Camping On or Queuing
for a trunk
On red while
camped on
-
Voice Response
System (VRS) (Park
and Page) (Personal
Greeting)
Code: 17
Operation: Press key
+ device type code +
requested data
(depends on device
selected).
Setting up Call Forwarding
Off-Premise, Selectable
Display Messaging, VRS
Park and Page and VRS
Personal Greeting
Flashes red
4
Voice Mail Code: 83 + code (0~4)
Operation: Press key
Using Voice Mail Service Flashes slowly
when monitoring
-
Code: 77 + extension
or Message Center
number
Operation: Press key
Calling Voice Mail or
leaving a message
Flashes green on
your key for your
messages or
flashes red for the
Message Center
8
or
8
Code: 78 + 0
Operation: Set up call
+ Press key
Using Voice Mail Record Slow Flash red
when active
-
Voice Over Code: 48
Operation: Hear
Off-Hook Signaling
tone + Press key
Initiating or responding to
Voice Over
On red when
responding Hold
Flash red when
listening
6
To program a key, press Speaker, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
press the key and enter the code (e.g., 48 for Voice Over).
For this feature... Use this key... When your are... Key Lamp Status
Also See
Srvc Code