UNIVERGE SV8100 Issue 1.0
Codes Tables 3 - 33
Code: 27
Operation: Press
key + bin + Line or
Speaker key
Speed Dialing Dialing a stored System
Speed Dialing number
None #2 + bin
Code: 28
Operation: Press
key + bin + Line or
Speaker key
Dialing a stored Group
Speed Dialing number
None #4 + bin
Code: 29
Operation: Place
call + Press key
Repeat Redial Activating repeat redial
while on a call
Fast Flash while
system waits to
redial
-
Code: 30
Operation:
Save
: Place call +
Press key
Redial
: Line or
Speaker key + Press
key
Save Number Dialed Saving, redialing or
checking a saved number
None 715
Code: 31
Operation:
Store
: While on call,
Press key + number
to store
Use
: Press key +
Speaker key or line
Erase:
Speaker key
+ Press key
Memo Dial Storing, using or checking
a Memo Dial number
None -
Code: 33
Operation: Call ext.
and receive busy +
Press key
Off-Hook Signaling Signaling a busy
extension
None 709
Code: 34
Operation: Call ext
+ Press key
Barge-In Barging In on a co-
worker’s conversation
None 710
Code: 35
Operation: Call
busy extension or
access busy trunk +
Press key
Callback / Camp-On /
Trunk Queuing
Leaving a Callback
request at a busy
extension, Camping On to
a busy extension, Queuing
for a busy trunk
On red when
activated
750
Code: 36
Operation: Dial
busy ext + Press key
Department Step
Calling
Step Calling through a
Department Group for an
idle member
None 708
To program a key, press Speaker, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
press the key and enter the code (e.g., 48 for Voice Over).
Use this key... For this feature... When you are... Key Lamp Status
Also see
Srvc Code
To Next Page
Loading...
