Issue 1.0 UNIVERGE SV8100
3 - 34 Codes Tables
Code: 37
Operation: Call
extension + Press
key
Call Forwarding / Do
Not Disturb Override
Overriding an extension’s
Call Forwarding or Do Not
Disturb
On red when
activated
707
Code: 38
Operation: Leave
message: Call ext +
Press key OR
Answer message:
Press key
Message Waiting Answering/Leaving a
Message Waiting
None
0
or
0
Code: 39
Operation: Press
key at destination
and source + ext
Room Monitor Activating Room Monitor Fast Flash red at
destination, Hold
Flash red at
source
-
Code: 40
Operation: Press
key
Handset Cutoff Cutting off the handset
transmission while on a
call
On when feature
active (no
transmission on
handset)
-
Code: 41 + sec. ext.
Operation: Press
key
Secretary Call Calling your secretary
(using the buzzer)
On red at source
Fast Flash red at
destination
-
Code: 42 + boss
ext.
Operation: Press
key
A secretary picking up a
call ringing your boss’s
extension.
On red when
activated
-
Code: 43
Operation: TRK call
+ Hold + ext + Press
key
Serial Call Placing a Serial Call to a
co-worker
None -
Code: 44
Operation: Place or
answer call + Press
key
Hold Putting a call on System
Hold (if hold key is
reassigned)
None -
Code: 45
Operation: Place or
answer call + Press
key
Putting a call on Exclusive
Hold
None -
Code: 46
Operation: Press
key
Department Calling Logging in or logging out
of your Department
Calling Group
On when
removed, Off
when installed
650
Code: 47 + dest.
ext.
Operation: Press
and hold key
Reverse Voice Over Initiating Reverse Voice
Over
Full BLF red -
To program a key, press Speaker, dial 751 (for
2-digit codes) or 752 (for 3-digit codes),
press the key and enter the code (e.g., 48 for Voice Over).
Use this key... For this feature... When you are... Key Lamp Status
Also see
Srvc Code
To Next Page
Loading...
