NEC Univerge SV8100 - Page 1375

UNIVERGE SV8100 Issue 1.0
Codes Tables 3 - 35
Code: 48
Operation: Hear
Off-Hook Signaling
tones + Press key
Voice Over Initiating or responding to
Voice Over
On red when
responding Hold
Flash red when
listening
690
Code: 49 + ext or
voice mail number
Operation: Press
key
Call Redirect Redirecting an incoming
call to an extension or
voice mail
On red when
activated
Flashes when in
DND/Call Forward
-
Code: 50
Operation: Press
key
Account Codes Entering Account Codes None

or
##
Code: 51 + relay
number
Operation: Press
key
General Purpose
Relay
Activating the general
purpose relay
On when active 780
Code: 55
Operation: Do not
Lift the handset +
Press key + Enter
extension number +
Enter name + Press
Hold
Name Storing Changing the name
displayed on your display
telephone
None 700
Code: 83 + 0~4
Operation: Press
key
Voice Mail Using Voice Mail Service Flashes slowly
when monitoring
-
Code: 77 +
extension or
Message Center
number
Operation: Press
key
Calling Voice Mail or
leaving a message
Flashes green on
your key for your
messages or
flashes red for the
Message Center
8
or
8
Code: 78 +
Conversation
Record
Operation: Press
key
Using Conversation
Record
Flashes red when
recording
-
Code:
01 + Trunk
number (001~200)
Operation: Press
key
Central Office Calls Pressing a line key to
place or answer a trunk
call (where trunks are
001~200)
On green when
seized, on red
when in use (by
other party), Slow
Flash green when
ringing, Hold flash
when on Hold
#9
To program a key, press Speaker, dial 751 (for 2-digit codes) or 752 (for 3-digit codes),
press the key and enter the code (e.g., 48 for Voice Over).
Use this key... For this feature... When you are... Key Lamp Status
Also see
Srvc Code