NEC Univerge SV8100 - Page 153

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 129
Operation
To place an outgoing call on hold and retrieve it using a multiline terminal:
1. Go off-hook using the handset and wait for internal dial tone.
- OR -
Press Speaker and wait for internal dial tone.
2. Dial the Trunk Access Code (default: 0).
3. Dial the outside party (the Call Appearance key lights). Begin your conversation.
4. Press Hold (the Call Appearance key flashes).
5. Press the flashing Call Appearance key to retrieve the call.
To receive an incoming call, put it on hold and then retrieve it using a Multiline Terminal:
1. Receive CO/PBX incoming ring.
2. Go off-hook using the handset, or press Speaker (the Call Appearance key lights). Talk with outside
party.
3. Press Hold (the Call Appearance key flashes).
4. Press the flashing Call Appearance key to retrieve the call.