NEC Univerge SV8100 - Page 166

Issue 1.0 UNIVERGE SV8100
2 - 142 Call Forwarding – Centrex
20-09-01 Class of Service Options
(Incoming Call Service) –
Second Call for DID/DISA/DIL/
E&M Override
Turns Off (0) or On (1) the
extension ability to receive a
second call from a DID, DISA, DIL,
or tie line caller.
 With this option set to 1, the
destination extension must be
busy for a second DNIS caller
to ring through. If the
destination extension does not
have a trunk or CAP key
available for the second call
and a previous call is ringing
the extension but has not yet
been answered, the second
caller hears busy regardless of
this program setting.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
Turns Off (0) or On (1) an extension
ability to have calls queued if a call
rings the extension when it is busy.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-13-05 Class of Service Options
(Supplementary Service) –
Intercom Off-Hook Signaling
Turns On (1) or Off (0) the ability of
an extension to receive Off-Hook
Signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
Manually (0) or Automatically (1)
receive Off-Hook signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
24-02-13 System Options for Transfer –
Hook Flash Sending Timer When
the System Answers
Automatically
Set the time the system waits
before sending the hookflash for the
Centrex Transfer after answering
the call.
0~64800 (seconds)
(default = 2)
3
24-09-06 Call Forward Split Settings – Call
Forwarding Destination for CTX/
PBX for All Call, No Answer
Use to assign Call Forwarding Type
and the destination numbers for
CTX/PBX all call, no answer.
1~9, 0, #, , R, @
(Up to 24 digits)
(default not assigned)
3
24-09-07 Call Forward Split Settings – Call
Forwarding Destination for CTX/
PBX for Busy
Use to assign Call Forwarding Type
and the destination numbers for
CTX/PBX busy calls.
1~9, 0, #, , R, @
(Up to 24 digits)
(default not assigned)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3