NEC Univerge SV8100 - Page 216

Issue 1.0 UNIVERGE SV8100
2 - 192 Call Waiting/Camp-On
Related Features
Callback
Off-Hook Signaling
Programmable Function Keys
Transfer
Trunk Queuing/Camp On
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
 Level 1 – these are the most commonly assigned programs for this feature.
 Level 2 – these are the next most commonly assigned programs for this feature.
 Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-11-23 Service Code Setup (for Setup/
Entry Operation) – Second Call
for DID/DISA/DIL
This service code enables Second
Call to each extension when
Program 20-09-01 (Second Call) is
set to 0 (disable).
MLT
(default = 679)
3
11-12-04 Service Code Setup (for Service
Access) – Set Camp-On
Customize the Service Code, which
is to be used for setting Camp-On.
MLT, SLT
(default = 750)
3
11-12-05 Service Code Setup (for Service
Access) – Cancel Camp-On
Customize the Service Code, which
is to be used for cancelling Camp-
On.
MLT, SLT
(default = 770)
3
11-12-47 Service Code Setup (for Service
Access) – Call Waiting Answer/
Split Answer
If required, use this program to
change the code users dial to Split
while on a call.
SLT
(default = 794)
3
11-16-05 Single Digit Service Code Setup
– Camp-On
Customize the 1-digit Service Code
used for setting Camp-On.
(default = #)
3
15-02-06 Multiline Telephone Basic Data
Setup – Hold Key Operating
Mode
Use this option to set the function of
the Multiline Hold key. Hold can
activate normal Hold or Exclusive
Hold.
0 = Normal (Common)
1 = Exclusive Hold
(default = 0)
3