Issue 1.0 UNIVERGE SV8100
2 - 214 Caller ID
5. Press the STA or SYS Softkey. The display shows:
6. Dial the Speed Dial bin in which the number is to be stored. If you press Hold, the next available
Speed Dial bin is used. The display shows:
If all Speed Dial bins are used, the display shows TABLE IS FULL.
7. Press HOLD. The display shows:
8. Enter the name to be associated with the stored number.
Store to SYS: COMMON
ENTER BIN
SYS XXXX:
xxxxxxxxxxxxx
SYS XXXX
-
Table 2-5 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
→ ← Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü
α ε θ
Enter characters:
+ , - . / : ; < = > ? π Σ σ Ω ¢ £
#
# = Accepts an entry (only required if two letters on the same key are needed
- ex: TOM). Pressing # again = Space. (In system programming mode, use
the right arrow Softkey instead to accept and/or add a space.)
CONF Clear the character entry one character at a time.
HOLD Clear all the entries from the point of the flashing cursor and to the right.
To Next Page
Loading...
