NEC Univerge SV8100 - Log On to Voice Mail

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 223
14-05-01 Trunk Group – Trunk Group
Number
Assign trunks to trunk groups then
go to Program 14-06-01 below to
set up Trunk Group Routing.
Trunks 1-200
Trunk Groups 1-100
Default = Trunks 1-200
assigned to trunk
group 1 with priorities
equal to the trunk
number.
Trunk 1 = Priority 1
Trunk 200 = Priority
200.
3
14-06-01 Trunk Group Routing – Priority
Order Number
Used to set the priority order
number 1~4.
0 = Not Specify 1~100 :
(Trunk Group Number)
1001~1100 : (1000 +
Route Table Number)
Default:
Route 1, Order
Number 1 = 1 (Trunk
Group 1)
Order Numbers 2, 3, 4
= 0 (Not Specified)
All Other Routes
(2~100) and Order
Numbers (1~4) = 0
(Not Specified).
3
14-07-01 Trunk Access Map Setup Set up the Trunk Access Maps. This
sets the access options for trunks.
Ring Group programming overrides
Access Map programming.
0 = No access
1 = Outgoing access
only
2 = Incoming access
only
3 = Access only when
trunk on Hold
4 = Outgoing access
and access when trunk
on Hold
5 = Incoming access
and access when trunk
on Hold
6 = Incoming and
Outgoing access
7 = Incoming access,
outgoing access and
access when trunk
on Hold
Trunk Access Maps:
1~200
Default:
Access Maps 1~200 =
Trunk Ports 1~200
assigned with option 7
access (incoming and
outgoing access and
access when trunk is
on Hold).
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3