NEC Univerge SV8100 - Page 248

Issue 1.0 UNIVERGE SV8100
2 - 224 Central Office Calls, Answering
15-01-05 Basic Extension Data Setup –
Restriction for Outgoing Disable
on Incoming Line
Enable or Disable supervised dial
detection for an extension.
0 = No
1 = Yes
(default = 0)
3
15-02-01 Multiline Telephone Basic Data
Setup – Display Language
Selection
(To select options 8~10, press
either 8 or Recall, then press line
keys 1~3. Key 1 is option 8, Key
2 is option 9, and Key 3 is option
10.)
Use to define the display language
for Multiline terminals. (To select
options 8~10, press either 8 or
Recall, then press line keys 1~3.
Key 1 is option 8, Key 2 is option 9,
and Key 3 is option 10.)
0 = Japanese
1 = English
2 = German
3 = French
4 = Italian
5 = Spanish
6 = Dutch
7 = Portuguese
8 = Norwegian
9 = Danish
10 = Swedish
11 = Turkish
12 = Latin American
Spanish
13 = Romanian
14 = Polish
(default = 1)
3
15-02-02 Multiline Telephone Basic Data
Setup – Trunk Ring Tone
Use this option to set the tone
(pitch) of the incoming trunk ring for
the extension port you are
programming.
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
(default = 2)
3
15-02-22 Multiline Telephone Basic Data
Setup – Multiple Incoming From
Intercom and Trunk
When this option is set to 0
(disabled), incoming calls to an
extension indicate on any Hotline
key for that extension as solid
(busy). When this option is set to 1
(enabled), lighting is determined by
the setting of Program 22-01-01
Incoming Call Priority. If set to trunk
priority (1), the Hotline key lights
solid when a trunk call rings in. If set
to intercom priority (0), the Hotline
key does not light for incoming trunk
calls, but lights solid for intercom
calls.
0 = Disable
1 = Enable
(default = 1)
3
15-03-03 Single Line Telephone Basic
Data Setup – Terminal Type
Enter 1 for this option to allow a
single line port to receive DTMF
tones after the initial call setup.
Enter 0 to have the port ignore
DTMF tones after the initial call
setup. For Voice Mail, always enter
1 (e.g., receive DTMF tones).
0 = Normal
1 = Special
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3