NEC Univerge SV8100 - Page 260

Issue 1.0 UNIVERGE SV8100
2 - 236 Central Office Calls, Placing
Operation
To place a call over a trunk group:
1. Go off-hook.
2. Dial 704.
3. Dial trunk group number (001~100).
4. Dial the number.
- OR -
1. At the multiline terminal, press the trunk group key (Program 15-07-01 or SC 751: 02 + group).
2. Dial the number.
To place a call using Trunk Group Routing:
1. Go off-hook.
2. Dial 0.
 If your system has an Alternate Trunk Route Access code, you may dial that instead.
82-08-01 Sidetone Volume Setup Use this program to adjust the
multiline terminal side tone volume.
There are two levels, based on
whether the connected trunk is a
digital trunk or analog trunk.
0-9
Digital Sidetone Level
0 = -54 (db)
1 = -48 (db)
2 = -42 (db)
3 = -36 (db)
4 = -30 (db)
5 = -24 (db)
6 = -18 (db)
7 = -12 (db)
8 = -12 (db)
9 = -12 (db)
Analog Sidetone Level
0 = -54 (db)
1 = -54 (db)
2 = -54 (db)
3 = -48 (db)
4 = -42 (db)
5 = -36 (db)
6 = -30 (db)
7 = -24 (db)
8 = -18 (db)
9 = -12 (db)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3