UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 349
11-11-28 Service Code Setup (for Setup/
Entry Operation) – Delayed
Transfer for Every Extension
Group
Use this service code to set the
delayed transfer destination
Department Group.
MLT, SLT
(default = 605)
3
11-11-29 Service Code Setup (for Setup/
Entry Operation) – Delayed
Transfer Cancellation for Each
Extension Group
Use this service code to cancel the
delayed transfer destination
Department Group.
MLT, SLT
(default = 606)
3
11-12-09 Service Code Setup (for Service
Access) – Change to STG
(Department Group) All Ring
Use this option to set the service
code for ringing all members of a
Department Group.
MLT, SLT
(default not assigned)
3
11-16-10 Single Digit Service Code Setup –
(Department) STG All Ring Mode
Assign the Single Digit (post-dialing)
Service Code for All Member Ring.
(default not assigned)
3
15-07-01 Programmable Function Keys Assign a Department Calling key
(46) so extension users can install
or remove themselves from the
Department Calling Group.
Additional keys can also be
assigned for Department Group
features immediate calling
destination (58), delayed calling
destination (59) and DND
destination (60).
Line Key 1~48
0~99 (Normal Function
Code 751 by default)
00 ~
99 (Appearance
Function Code) (Service
Code 752 by default)
3
16-01-01 Department Group Basic Data
Setup – Department Name
Assign a name to the Extension
(Department) Groups.
Maximum 12 characters
(default not assigned)
3
16-01-02 Department Group Basic Data
Setup – Department Calling Cycle
Set the routing cycle for calls into a
department (i.e., when a user dials
the department pilot number). The
system can ring the highest priority
extension available (Priority
Routing, 0) or cycle in circular order
to a new idle extension for each
new call (Circular Routing, 1).
0 = Normal Routing
(Priority)
1 = Easy – UCD Routing
(Circular)
(default = 0)
3
16-01-03 Department Group Basic Data
Setup – Department Routing
When Busy (Auto Step Call)
Set how the system routes an
Intercom call to a busy Department
Group member. The caller can hear
busy tone (0) or overflow to the first
available Department Group
member (1). This option is for
Intercom calls to an extension, not a
pilot number.
0 = Normal (Intercom
caller to busy
department member
hears busy)
1 = Circular (Intercom
callers to busy
department member
routes to idle member)
(default = 0)
3
16-01-04 Department Group Basic Data
Setup – Hunting Mode
Set if an unanswered call should
hunt once stopping at the last
member tried (0) or continually hunt
through the idle members (1).
0 = Last extension is
called and hunting is
stopped
1 = Circular
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
