NEC Univerge SV8100 - Page 404

Issue 1.0 UNIVERGE SV8100
2 - 380 Direct Inward Dialing (DID)
22-04-01 Incoming Extension Ring
Group Assignment
Assign extensions to Ring Groups.
Calls ring the extensions according
to programming in Program 22-06.
Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring for
incoming Ring Group 1
calls. No other
extensions ring for
incoming Ring Group 1
calls.
3
22-09-01 DID Basic Data Setup –
Expected Number of Digits
For each DID Translation Table
(1~20), enter the number of digits
the table expects to receive from the
CO (eight maximum). For example,
for a table used with 3-digit DID
service, enter 3.
1~8
(default = 2)
3
22-09-02 DID Basic Data Setup –
Received Vacant Number
Operation
Use this option to Enable or Disable
Vacant Number Intercept.
0 = Disconnect
1 = Transfer
(default = 0)
3
22-10-01 DID Translation Table Setup Assign the start and end range of
DID Translation Table entries
(1~2000) to each DID Translation
Table (1~20).
Trans Table 1 = 001~200
Trans Table 2 = 201~400
Trans Table 3 = 401~600
Trans Tabgle 4 601~700
3
22-11-01 DID Translation Number
Conversion – Received
Number
For each DID Translation Table
entry (1~2000), specify the digits
received by the system.
Conv Table 001~100 =
01~99,00
Conv Table 201~300 =
01~99,00
Conv Table 301~500 =
01~99,00
Conv Table 401~600 =
01~99,00
3
22-11-02 DID Translation Number
Conversion – Target Number
For each DID Translation Table
entry (1~2000), specify the
extension the system dials after
translation.
Conv Table 001~100 =
101~199,100
Conv Table 201~300 =
101~199,100
Conv Table 301~500 =
101~199,100
Conv Table 401~600 =
101~199,100
3
22-11-03 DID Translation Number
Conversion – DID Name
For each DID Translation Table
entry (1~2000), specify the name
that should show on the dialed
extension display when it rings.
Maximum 12 digits
(default not assigned)
3
22-11-04 DID Translation Number
Conversion – Transfer
Operation Mode
For each DID Translation Table
entry (1~2000), specify the condition
required to transfer the call to the
destination defined in Program 22-
11-05 and Program 22-11-06.
0 = No Transfer
1 = Busy
2 = No Answer
3 = Both
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3