NEC Univerge SV8100 - Page 405

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 381
22-11-05 DID Translation Table Number
Conversion – Transfer
Destination Number 1
Use to define the 1st transfer
destination for each tables received
number.
0 = No Setting
1~100 = Incoming Group
101 = (Not Used)
102 = In-Skin/External
Voice Mail or In-Mail
201~264 = Extension
Group
400 = Valid Extension
Number
401 = DISA
501~548 = DISA/VRS
Message
1000~1999 = Speed
Number
(000~999)
(default = 0)
3
22-11-06 DID Translation Table Number
Conversion – Transfer
Destination Number 2
400 = Allows the outside party to dial
a different extension number in the
translation table (for example, ring
no answer to a dialed number, the
caller then hears a dial tone,
allowing them to enter another Valid
Extension Number).
401 = Provides the caller with DISA
dialing options (requires using the
DISA password).
Note: This applies to 22-11-05 and
22-11-06.
 If the Transfer Destinations are
busy or receive no answer,
those calls are transferred to
the final transfer destination
(Program 22-10).
3
22-11-07 DID Translation Number
Conversion – Call Waiting
For each DID Translation Table
entry (1~2000), specify whether or
not Call Waiting should be allowed
(0 = Disable, 1 = Enable).
0 = Disable (No)
1 = Enable (Yes)
(default = 0)
3
22-11-08 DID Translation Number
Conversion – Maximum
Number of DID Calls
For each DID Translation Table
entry (1~2000), specify the
maximum number of DID calls.
0~200 (0 = No Limit)
(default = 0)
3
22-11-09 DID Translation Number
Conversion – Music On Hold
Source
For each DID Translation Table
entry (1~2000), specify the source of
music to be used for DID trunks.
0 = IC/MOH Port
1 = BGM Port
2 = ACI Port
(default = 0)
3
22-11-10 DID Translation Number
Conversion – ACI Music
Source Port
For each DID Translation Table
entry (1~2000), if item 2 is selected
in Program 22-11-09, specify the
port to be used for the source of
music heard on DID trunks.
When a sound source
type is 2 in above :
(0~96)
(default = 0)
3
22-11-11 DID Translation Number
Conversion – Ring Group
Transfer
Enable (1) or disable (0) each
conversion table to follow the Ring
Group programming defined in
Program 22-12-01 : DID Intercept
Ring Group. If Program 22-11-05 :
DID Translation Number
Conversion, Transfer Destination
Number 1 and Program 22-11-06 :
DID Translation Number
Conversion, Transfer Destination
Number 2 are set, the priority of
transferring is in this order: Program
22-11-05 then Program 22-11-06
then if Program 22-11-11 is enabled,
Program 22-12-01.
1~2000
0 = Disable (Caller hears
Ringback)
1 = Enable (Go to normal
ring)
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3