NEC Univerge SV8100 - Page 406

Issue 1.0 UNIVERGE SV8100
2 - 382 Direct Inward Dialing (DID)
22-12-01 DID Intercept Ring Group For each DID Translation Table,
program the DID Intercept
destination. The destination can be a
Ring Group, In-Skin/External Voice
Mail, or Centralized Voice Mail. This
program is used when there is no
destination programmed in Program
22-11-05. It is unrelated to Program
22-11-06 and Program 22-11-07.
0 (No Setting)
1~100 (Incoming Ring
Group)
102 (In-Skin/External
Voice Mail or VM8000
InMail)
(default = 1)
3
22-13-01 DID Trunk Group to
Translation Table Assignment
Assign the DID trunk groups to
translation tables. If all the DID
trunks use the same type of DID
service, you may have only one DID
trunk group and one DID Translation
Table (with many entries).
0~20
(0 = No Setting)
(default = 1)
3
25-01-01 VRS/DISA Line Basic Data
Setup – VRS/DISA Dial-In
Mode
Determine whether the system
should use option 0 (Extension
number/Service code specify) or
option 1 (Use dial conversion table)
for calls.
0 = Extension Number
Service Code Specify
(Intercom)
1 = Use Dial Conversion
Table
(default = 0)
3
25-01-03 VRS/DISA Line Basic Data
Setup – VRS/DISA Transfer
Alarm
Determine whether the system
should use option 0 (Normal) or
option 1 (Alarm) for calls.
0 = Normal
1 = Alarm
(default = 0)
3
25-02-01 VRS/DISA VRS Message For each trunk port and each night
mode, select the message source (0
= No Message, 1 = VRS, 2 = ACI, 3
=S LT), assign the VRS message
number to be used as the
Automated Attendant Message for
each trunk, which is assigned as
VRS/DISA [with VRS = 01~48 (VRS
message number), with ACI = 1~4 or
01~16 (ACI group number), with SLT
= 1~8 or 01~64 (Department Group
number)].
0 = No Message
1 = 01~100 (VRS
Messages)
2 = 01~4 (ACI Group
Number)
3 = 01~64 (Extension
Group Number)
(default = 0)
3
25-03-01 VRS/DISA Transfer Ring Group
With Incorrect Dialing
For each trunk port, set what
happens to a call when the DISA or
Automated Attendant caller dials
incorrectly or waits too long to dial.
The call can either disconnect (0) or
Transfer to an alternate destination
(a ring group, In-Skin/External,
Centralized). When setting the DISA
and DID Operating Mode, you make
an entry for each Night Service
mode.
(Mode 1~8) All Trunks =
Ring Group 1
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3