UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 383
25-04-01 VRS/DISA Transfer Ring Group
With No Answer/Busy
For each trunk port (001~200), set
the operating mode of each DISA
trunk. This sets what happens to the
call when the DISA or Automated
Attendant caller calls a busy or
unanswered extension. The call can
either disconnect (0) or Transfer to
an alternate destination (a ring
group, In-Skin/External,
Centralized). When setting the DISA
and DID Operating Mode, you make
an entry for each Night Service
mode.
Ring Groups:
1~100
Trunk Ports:
001~200
Day/Night Mode:
1~8
0 (Disconnect)
1~100 (Incoming Ring
Group)
102 (In-Skin/External
Voice Mail or VM8000
InMail)
(default = 0)
3
25-05-01 VRS/DISA Error Message
Assignment
For each trunk that is answered by
the VRS, enter the VRS message
(1~48) the outside caller hears if
they dial incorrectly after answer. If
you enter 0, the call reroutes
according to Program 25-03 and
Program 25-04. Make one entry for
each Night Service mode.
0~100 (0 = No Setting)
(default = 0)
3
25-06-02 VRS/DISA One-Digit Code
Attendant Setup – Destination
Number
Set up single digit dialing for
Automated Attendant callers. For
each VRS Message programmed to
answer outside calls, specify:
The digit the Automated
Attendant caller dials (1~12,
where 10 = 0, 11 = and 12 =
#).
(Keep in mind that if you assign
destinations to digits three and
four, outside callers cannot dial
system extensions that begin with
that digit.)
The destination reached (four
digits maximum) when the caller
dials the single digit code.
Up to eight digits
(default not assigned)
3
25-07-01 System Timers for VRS/DISA –
VRS/DISA Dial Tone Time
After answering a VRS/DISA trunk,
the system waits this time for the
caller to dial the first digit of the DISA
password. If the caller fails to dial in
this time, the system drops the call.
0~64800 (seconds)
(default = 10 seconds)
3
25-07-02 System Timers for VRS/DISA –
VRS/DISA No Answer Time
A VRS/DISA caller can ring an
extension for this time before the
system sets the call as a Ring No
Answer. After this time expires, the
call follows the programmed Ring No
Answer routing (set in Program 25-
03 and Program 25-04).
0~64800 (seconds)
(default = 0 seconds)
3
25-07-04 System Timers for VRS/DISA –
Calling Time to Automatic
Answering Telephone Set
Set the answering waiting time of the
automatic answering extension
when an incoming DID trunk call is
received.
0~64800 (seconds)
(default = 10 seconds)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
