UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 397
Transfer
Voice Response System (VRS)
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
10-09-01 DTMF and Dial Tone Circuit
Setup
Reserve at least one circuit for DTMF
reception (entry 0 or 2).
Use the following as a guide when
allocating DTMF receivers:
In light traffic sites, allocate one
DTMF receiver for every 10
devices that use them.
In heavy traffic sites, allocate one
DTMF receiver for every five
devices that use them.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
3
11-01-01 System Numbering Used to define the system numbering
plan.
Refer to UNIVERGE
SV8100 System
Program Manual
3
11-09-02 Trunk Access Code – 2nd Trunk
Route Access Code
Assign the Service Code set up in
Program 11-01 for 2
nd
(Alternate)
Trunk Route Access.
Dial (up to four digits)
(default not assigned)
3
14-01-02 Basic Trunk Data Setup –
Transmit Level
Customize the transmit and receive
levels of the CODEC Gain Types for
each trunk.
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
3
14-01-03 Basic Trunk Data Setup –
Receive Level
Customize the transmit and receive
levels of the CODEC Gain Types for
each trunk.
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
3
To Next Page
Loading...
