NEC Univerge SV8100 - Page 422

Issue 1.0 UNIVERGE SV8100
2 - 398 Direct Inward System Access (DISA)
14-01-13 Basic Trunk Data Setup –
Trunk-to-Trunk Transfer
If DISA caller can place outgoing
calls through the system (refer to
Program 20-14 in the UNIVERGE
SV8100 Programming Manual),
enable loop supervision (1) for the
DISA trunk. If DISA caller cannot use
the system trunks for outgoing calls,
enter 0 to disable loop supervision.
0 = Disable
1 = Enable
(default = 1)
3
20-01-05 System Options – DTMF Receive
Active Time
After answering the call, the system
attaches a DTMF receiver to the
DISA trunk for this time.
0~64800 (seconds)
(default = 10 seconds)
3
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15) to
an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-09-01 Class of Service Options
(Incoming Call Service) –
Second Call for DID/DISA/DIL/
E&M Override
Turns Off or On the extension ability
to receive a second call from a DID,
DISA, DIL, or tie line caller.
 With this option set to 1, the
destination extension must be
busy for a second DNIS caller
to ring through. If the destination
extension does not have a trunk
or CAP key available for the
second call and a previous call
is ringing the extension but has
not yet been answered, the
second caller hears busy
regardless of this program
setting.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-13-23 Class of Service Options
(Supplementary Service) –
Display the Reason for Transfer
Select whether an extension should
display the reason a call is being
transferred to their extension (Call
Forward Busy, Call Forward No
Answer, DND).
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-14-01 Class of Service Options for
DISA/E&M – First Digit
Absorption (Delete First Digit
Dialed)
For tie lines, Enable or Disable the
ability to absorb (ignore) the first
incoming digit. Use this to make the
tie trunk compatible with
3- and 4-digit tie line service. This
option does not apply to DISA.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-14-02 Class of Service Options for
DISA/E&M – Trunk Group
Routing/ARS Access
This option Enables or Disables a
DISA or tie trunk caller ability to dial 9
for Trunk Group Routing or
Automatic Route Selection (ARS).
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3