EasyManua.ls Logo

NEC Univerge SV8100 - Page 424

NEC Univerge SV8100
1386 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Issue 1.0 UNIVERGE SV8100
2 - 400 Direct Inward System Access (DISA)
22-02-01 Incoming Call Trunk Setup For DISA operation, set the trunk
service type to 2. You can have a
different service type for each Night
Service mode.
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
3
22-04-01 Incoming Extension Ring Group
Assignment
Assign the extensions that should
receive the overflow. Set the ringing
in Program 22-06.
Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring
for incoming Ring
Group 1 calls. No
other extensions ring
for incoming Ring
Group 1 calls.
3
25-01-01 VRS/DISA Line Basic Data Setup
– VRS/DISA Dial-In Mode
Select whether the DISA trunk uses
Extension number/Service code
specify (0) or Dial Conversion Table
(1).
0 = Extension Number
Service Code Specify
(Intercom)
1 = Use Dial
Conversion Table
(default = 0)
3
25-01-02 VRS/DISA Line Basic Data Setup
– DISA User ID
Select whether or not the DISA User
IDshould be used.
0 = Off
1 = On
(default = 0)
3
25-01-03 VRS/DISA Line Basic Data Setup
– VRS/DISA Transfer Alarm
Select whether the DISA transfer
alarm should be used.
0 = Normal
1 = Alarm
(default = 0)
3
25-02-01 VRS/DISA VRS Message Assign the source and VRS message
number to be used as the Automated
Attendant Message for each trunk
(001~200) which is assigned as a
VRS/DISA.
0 = No Message
1 = 01~100 (VRS
Messages)
2 = 01~4 (ACI Group
Number)
3 = 01~64 (Extension
Group Number)
(default = 0)
3
25-03-01 VRS/DISA Transfer Ring Group
With Incorrect Dialing
Set the operating mode of each DISA
trunk. This sets what happens to the
call when the DISA caller dials
incorrectly. The call can either
disconnect (0), transfer to an
alternate ring group destination, or
transfer to In-Skin/External Voice
Mail, or Centralized Voice Mail.
(Mode 1~8) All Trunks
= Ring Group 1
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3

Table of Contents

Other manuals for NEC Univerge SV8100

Related product manuals