UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 403
25-07-08 System Timers for VRS/DISA –
Long Conversation Disconnect
Time
This time determines how long the
system waits before disconnecting a
a DISA or any automatically
transferred trunk-to-trunk (such as
Tandem Trunking) call after the Long
Conversation tone is heard.
0~64800 (seconds)
(default = 30 seconds)
3
25-07-09 System Timers for VRS/DISA –
DISA Internal Paging Time
This is the maximum length of an
Internal Page placed by a DISA
caller. If the Page continues longer
than this time, the system terminates
the DISA call.
0~64800 (seconds)
(default = 30 seconds)
3
25-07-10 System Timers for VRS/DISA –
DISA External Paging Time
This is the maximum length an
External Page is placed by a DISA
caller. If the Page continues longer
than this time, the system terminates
the DISA call.
0~64800 (seconds)
(default = 30 seconds)
3
25-07-11 System Timers for VRS/DISA –
VRS/DISA Answer Delay Time
Set the time the system waits after
receiving an incoming VRS/DISA call
before the system automatically
answers the call (0~64800 seconds).
0~64800 (seconds)
(default = 0 seconds)
3
25-07-13 System Timers for VRS/DISA –
VRS/DISA Busy Tone Interval
If a DISA caller dials a busy
extension (and Program 25-04 = 0),
the system plays busy tone for this
time before disconnecting.
0~64800 (seconds)
(default = 5 seconds)
3
25-07-14 System Timers for VRS/DISA –
Delayed VRS Answer Time
Assign the delay time from switching
from a normal incoming status to DID
Mode. If this time is set to 0, the call
switches to DID immediately.
0~64800 (seconds)
(default = 10 seconds)
25-08-01 DISA User ID Setup – Password For each DISA user, set the 6-digit
password.
ID 01 = 000001
ID 02 = 000002
:
ID 15 = 000015
3
25-09-01 Class of Service for DISA Users Assign a DISA Class of Service for
each user. Assign the DISA Class of
Service options in Program 20-14.
The DISA Class of Service cannot be
0. Program 20-06 cannot be used to
assign Class of Servise to DISA
trunks.
Day/Night Mode = 1~8
Function Class = 1~15
(default = 1)
3
25-10-01 Trunk Group Routing for DISA Use this program to assign the Trunk
Group Route chosen when a user
places a DISA call into the system
and dials 0. Set Trunk Group Routing
in Program 14-06. Enable or Disable
DISA caller ability to dial 9 in
Program 20-14-02. Assign a route to
each DISA Class of Service (1~15).
The system assigns a DISA Class of
Service to a call based on the
password the DISA caller dials.
Day/Night Mode = 1~8
Route Table Number =
0~100
(0 = No Setting)
(default = 1)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
To Next Page
Loading...
