NEC Univerge SV8100 - Page 428

Issue 1.0 UNIVERGE SV8100
2 - 404 Direct Inward System Access (DISA)
Trunk Continue/Disconnect Codes
25-11-01 DISA Toll Restriction Class If the system uses Toll Restriction,
enter a Toll Restriction Class (1~15)
for each DISA user (1~15). The
system uses the Toll Restriction
Class you enter in Program 21-05
and 21-06. The Toll Restriction Class
assigned to a DISA call is based on
the DISA Class of Service and user,
which is determined by the password
the caller dials. You cannot use
Program 21-04 cannot be used to
assign Toll Restriction to DISA
trunks.
Day/Night Mode = 1~8
Toll Restriction Class =
1~15
(default = 2)
3
25-12-01 Alternate Trunk Group Routing
for DISA
Assign the trunk route that DISA
Callers access if they dial the
Alternate Trunk Route Access Code.
Refer to Central Office Calls, Placing
on page 2-229 for more information
on setting up Alternate Trunk Route
Access.
Day/Night Mode = 1~8
Route Table Number =
0~100
(0 = No Setting)
(default = 1)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
14-01-25 Basic Trunk Data Setup –
Continued/Discontinued
Trunk-to-Trunk Conversation
When Program 24-02-10 is set to
disconnect a trunk after the defined
time, determine whether or not a
user should have the ability to use
the continue/disconnect code.
0 = Disable (No)
1 = Enable (Yes)
(default = 0)
3
22-07-01 DIL Assignment Assign the master/pilot number of
the voice mail group from Program
11-07-01 as the DIL destination. If all
Voice Mail ports are in the same
unique Extension (Department)
Group (see Program 16-02 above),
the DIL rings another Voice Mail port
if its assigned port is busy.
Extension Number
(maximum eight digits)
(default not assigned)
3
20-28-01 Trunk to Trunk Conversation –
Conversation Continue Code
When Program 14-01-25 is enabled,
determine the 1-digit code the user
should dial (0~9, ,
#) to extend the
conversation for the time defined in
Program 20-28-03. If the Continue
and Disconnect codes are
programmed the same (e.g.,
#), the
system follows the "Continue"
operation. Using the Continue code
before the warning tone is heard has
no action.
0~9, #, 
(default not assigned)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3