UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 429
20-15-09 Ring Cycle Setup – Callback Used to define the ringing cycle for
Callback.
Ringing Cycle = 1~13
(default = 11)
3
20-15-10 Ring Cycle Setup – Alarm for
SLT
Used to define the ringing cycle for
Alarm for SLT.
Ringing Cycle = 1~13
(default = 5)
3
20-15-11 Ring Cycle Setup – VRS Waiting
Message Incoming
Call
Used to define the ringing cycle for
Incoming VRS Waiting Message.
Ringing Cycle = 1~13
(default = 8)
3
22-03-01 Trunk Ring Tone Range Set the ring tone range (1~9) for
each trunk.
0~8
(Ring Tone Pattern
1~4)
(Melody 1~ Melody 5)
(default = 0)
3
80-01-01 Service Tone Setup – Repeat
Count
Customize the system basic tones
and system service tones. You
need to reset for the changes to
take affect.
0~255
(default 0 = until
On-Hook)
3
80-01-02 Service Tone Setup – Basic Tone
Number
The following features require that
the system tones listed below be
changed to match the table. After
changing these settings the chassis
must be reset for the changes to
take effect.
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer
1~33
(0 = No Tone)
(33 = Default Time
Slot)
Refer to Table 2-10
Basic Tone Table –
Tone 06 on page 2-430
3
80-01-02
(14)
Service Tone Setup – Basic Tone
Number
The following features require that
the system tones listed below be
changed to match the table. After
changing these settings the chassis
must be reset for the changes to
take effect.
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer
Refer to Table 2-11
Basic Tone Table –
Tone 14 on page 2-430
3
80-01-02
(39)
Service Tone Setup – Basic Tone
Number
The following features require that
the system tones listed below be
changed to match the table. After
changing these settings the chassis
must be reset for the changes to
take effect.
Call Screening
Call Holding
Busy Greeting
Await Answer Transfer
Refer to Table 2-12
Basic Tone Table –
Tone 39 on page 2-430
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3