NEC Univerge SV8100 - Page 470

Issue 1.0 UNIVERGE SV8100
2 - 446 Drop Key
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
 Level 1 – these are the most commonly assigned programs for this feature.
 Level 2 – these are the next most commonly assigned programs for this feature.
 Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-12-42 Service Code Setup (for Service
Access) – Flash on Trunk lines
Use to customize the flash on trunk
lines Service Codes.
SLT
(default =
#3)
3
11-12-59 Service Code Setup (for Service
Access) – Trunk Drop Operation
for SLT
Use to customize the trunk drop
operation for SLT Service Codes.
SLT
(default not assigned)
3
14-02-03 Analog Trunk Data Setup – Flash
Type
Use this option to select the flash
type.
0 = Open Loop Flash
1 = Ground
Always set this option
for Open Loop Flash
(0)
(default = 0)
3
14-02-04 Analog Trunk Data Setup –
Hooking Type
This option lets you use Flash for
Timed Flash (Program 81-01-14) or
Disconnect (Program 81-01-15). (A
user implements Flash by pressing
the FLASH key while on a trunk
call.)
0 = Timed Flash
(Hooking)
1 = Disconnect (Cut)
(default = 0)
3
15-02-05 Multiline Telephone Basic Data
Setup – Transfer Key Operation
Mode
If the Conf key should access
Flash, enter 2. Otherwise, enter 0 or
1.
0 = Transfer
1 = Call back
2 = Hook
(default = 0)
3
15-03-04 Single Line Telephone Basic
Data Setup – Flashing
Enables/disables Flash for single
line (500/2500 type) telephones.
0 = No
1 = Yes
(default = 1)
3
15-07-01 Programmable Function Keys Assign a function key for Drop Key
(code 84) if required.
Line Key 1~48
0~99 (Normal Function
Code 751 by default)

00 ~

99
(Appearance Function
Code) (Service Code
752 by default)
3