Issue 1.0 UNIVERGE SV8100
2 - 544 Forced Trunk Disconnect
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-10-26 Service Code Setup (for System
Administrator) – Forced Trunk
Disconnect
Assign the Service Code. MLT, SLT
(default not assigned)
3
20-06-01 Class of Service for Extensions Assign a Class of Service (COS)
to an extension. There are 15
Classes of Service that can be
assigned. Assign eight entries,
one for each Night Service Mode.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-07-11 Class of Service Options
(Administrator Level) – Forced
Trunk Disconnect (analog trunk
only)
Turns Off or On an extension to
use Forced Trunk Disconnect.
This allows the extension to
disconnect an Unsupervised
Conference in progress.
0 = Off
1 = On
(default = 0 for
COS 1~14)
(default = 1 for
COS 15)
3
21-01-18 System Options for Outgoing
Calls – Reset Dial After Failure of
Trunk Access
Enable or Disable an extension
user ability to continue to dial
codes or extensions after
receiving Trunk Busy. This must
be Enabled for this feature to
work.
0 = Disable
1 = Enable
(default = 1)
3
To Next Page
Loading...
