UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 573
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-12-30 Service Code Setup (for
Service Access) – Specified
Trunk Answer
If required, redefine the service
code used to answer a specific
trunk which is either ringing or on
hold.
MLT, SLT
(default = 672)
3
11-12-33 Service Code Setup (for
Service Access) – Group
Hold
If required, redefine the service
code used to answer a specific
trunk which is either ringing or on
hold.
MLT, SLT
(default = 732)
3
11-12-34 Service Code Setup (for
Service Access) – Answer for
Group Hold
If required, redefine the service
code used to answer a specific
trunk which is either ringing or on
hold.
MLT, SLT
(default = 762)
3
14-01-16 Basic Trunk Data Setup –
Forced Release of Held Call
Enable (1) or disable (0) Forced
Release of Held Call.
0 = Disable
1 = Enable
(default = 0)
3
To Next Page
Loading...
