NEC Univerge SV8100 - Page 598

Issue 1.0 UNIVERGE SV8100
2 - 574 Hold
14-07-01 Trunk Access Map Setup Set up the Trunk Access Maps.
This sets the access options for
trunks.
0 = No access
1 = Outgoing access only
2 = Incoming access only
3 = Access only when
trunk on Hold
4 = Outgoing access and
access when trunk on
Hold
5 = Incoming access and
access when trunk on
Hold
6 = Incoming and
Outgoing access
7 = Incoming access,
outgoing access and
access when trunk on
Hold
Trunk Access Maps:
1~200
Default:
Access Maps 1~200 =
Trunk Ports 1~200
assigned with option 7
access (incoming and
outgoing access and
access when trunk is on
Hold).
3
15-02-06 Multiline Telephone Basic
Data Setup – Hold Key
Operating Mode
Use this option to set the function of
the Multiline Hold key. The Hold key
can activate normal Hold or
Exclusive Hold.
0 = Normal (Common)
1 = Exclusive Hold
(default = 0)
3
15-02-07 Multiline Telephone Basic
Data Setup – Automatic Hold
for CO Lines
Determines whether an extension
will disconnect the trunk line (1) or
automatically hold it (0) when you
direct select a CO line without
placing the call on hold first.
Automatic Hold does not work until
the elapse call timer is displayed.
0 = Hold
1 = Disconnect (Cut)
(default = 1)
3
15-02-11 Multiline Telephone Basic
Data Setup – Callback
Automatic Answer
Enable (1) or disable (0) Callback
Automatic Answer.
0 = Off
1 = On
(default = 1)
3
15-06-01 Trunk Access Map for
Extensions
Assign Trunk Access Maps to
extensions.
Trunks 1~200
(default = 1)
3
15-07-01
Programmable Function Keys
Assign a function key for Exclusive
Hold (code 45). If an extension has
its fixed Hold key reassigned (in
Program 15-02-06), assign a
function key for System Hold (code
44).
Line Key 1~48
0~99 (Normal Function
Code 751 by default)

00 ~

99 (Appearance
Function Code) (Service
Code 752 by default)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3