NEC Univerge SV8100 - Page 630

Issue 1.0 UNIVERGE SV8100
2 - 606 Intercom
Handsfree Answerback/Forced Intercom Ringing:
20-18-01 Service Tone Timers – Extension
Dial Tone Time
After getting Intercom dial tone, a
multiline terminal user has this time
to dial the first digit of the Intercom
call.
0~64800 (seconds)
(default = 30 seconds)
3
21-01-02 System Options for Outgoing
Calls – Intercom Interdigit Time
When placing Intercom calls, users
must dial each digit within this time.
0~64800 (seconds)
(default = 10 seconds)
3
82-01-01
(01)
Incoming Ring Tone –
Frequency 1
Customize the Intercom ring tone. 1 = 520Hz
2 = 540Hz
3 = 660Hz
4 = 760Hz
5 = 1100Hz
6 = 1400Hz
7 = 2000Hz
Default:
Refer to Table 2-17
Incoming Ringing Tone
on page 2-607
3
82-01-02 Incoming Ring Tone –
Frequency 2
Customize the Intercom ring tone.
3
82-01-03 Incoming Ring Tone –
Modulation
Use this program to customize the
Intercom Ring Tone modulation if
desired.
0 = No Modulation
1 = 8Hz Modulation
2 = 16Hz Modulation
3 = Envelope
(default =
2)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
20-02-12 System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
Determine if an extension ICM calls
should be set as Forced Intercom
Ringing (1). If disabled (0), Intercom
calls voice-announce.
0 = Disable (Voice)
1 = Enable (Signal)
(default = 1)
3
20-06-01 Class of Service for Extensions Assign Class of Service (1~15) for
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-08-10 Class of Service Options
(Outgoing Call Service) – Signal/
Voice Call
Turns Off or On an extension
allowing it to force Handsfree
Answerback or Forced Intercom
Ringing for outgoing Intercom calls.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-09-05 Class of Service Options
(Incoming Call Service) – Signal/
Voice Call
Turns Off or On an extension ability
to enable Handsfree Answerback or
Forced Intercom Ringing for their
incoming Intercom calls.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3