Issue 1.0 UNIVERGE SV8100
2 - 632 IP Trunk – (SIP) Session Initiation Protocol
System Availability
Terminals
All Multiline Terminals
Required Component(s)
Related Features
None
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
10-12-03 CD-CP00-AU Network Setup –
Default Gateway
Assign the default gateway IP
address for the CD-CP00-AU.
0.0.0.0 ~
126.255.255.254
128.0.0.1 ~
191.254.255.254
192.0.0.1 ~
223.255.255.254
(default = 0.0.0.0)
3
10-12-05 CD-CP00-AU Network Setup –
NIC Interface
Use to setup the NIC Interface. 0 = Auto Detect
1 = 100Mbps, Full
Duplex
2 = 100Mbps, Half
Duplex
3 = 10Mbps, Full Duplex
4 = 10Mbps, Half Duplex
(default = 0)
3
10-12-06 CD-CP00-AU Network Setup –
NAPT Router
Used to define if using an external
NAT router or not.
0 = No (Disable)
1 = Yes (Enable)
(default = 0)
3
To Next Page
Loading...
