NEC Univerge SV8100 - Page 685

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 661
10-03-08 ETU Setup (BRIA PKG Setup) –
Dial Sending Mode
ISDN protocol definition. Select
either enblock or overlap sending.
0 = Enblock Sending
1 = Overlap Sending
(default = 1)
3
10-03-09 ETU Setup (BRIA PKG Setup) –
Dial Information Element
ISDN Protocol definition. If
Overlap Sending is selected in
Program 10-03-08, select either
Keypad Facility (0) or Called Party
Number (1) for the dial information
element.
0 = Keypad Facility
1 = Called Party Number
(default = 0)
3
10-03-13 ETU Setup (PRTA PKG Setup) –
Loss of Signal Detection Limit
If the transmit/receive voltage is
less than the setting in Program
10-03-13, the system considers
this as Loss-Of-Signal and the PRI
does not come up. Note that there
are different values based on the
setting in Program 10-03-12 for
the PRI.
0 = Level 0
(lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7
(highest sensitivity)
(default = 2)
3
10-06-01 ISDN BRI Setup – TEI Selection Select the method the system
uses when assigning Terminal
Endpoint Identifier (TEI) values to
the BRI Circuit.
0 = Select by SPID
number
1 = Select by Channel ID
Number
(default = 0)
3
10-06-02 ISDN BRI Setup – DID Mode Select the method the system
uses when assigning DID Mode to
the BRI Circuit.
0 = Route by Called
Party Number
1 = Route by Redirecting
Number
(default = 0)
3
10-06-03 ISDN BRI Setup – SPID 1 Assign the SPID Number for
B-Channel 1.
Dial up to 20 digits
(default not assigned)
3
10-06-04 ISDN BRI Setup – SPID 2 Assign the SPID Number for
B-Channel 2.
Dial up to 20 digits
(default not assigned)
3
21-12-01 ISDN Calling Party Number
Setup for Trunks – Calling Party
Number Data
Assign Calling Party Numbers for
each trunk (maximum 16 digits per
entry).
 After the above programming
is complete a reset of the
CD-2BRIA is required.
(maximum 16 digits)
1-0, ,
#
Default:
(All trunks = No setting)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3