NEC Univerge SV8100 - Page 690

Issue 1.0 UNIVERGE SV8100
2 - 666 ISDN Compatibility
ISDN – PRI Network Specific Assignment
SMDR Dialed Digits for either ISDN – BRI or PRI
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
26-02-07 Dial Analysis Table for ARS/LCR
– Network Specified Parameter
Table
Use this program to define the
network specified parameter table
for each ARS Table.
0~16
(default = 0)
3
26-12-01 Network Specified Parameter
Table for ARS – Type of Number
Use this program to define the
type of Number parameter for an
ISDN outgoing call.
0 = System Default
1 = Unknown
2 = International No.
3 = National No.
4 = Network Specific
No.
5 = Subscriber No.
6 = Abbreviated No.
(default = 0)
3
26-12-02 Network Specified Parameter
Table for ARS – Numbering Plan
Identification
Use this program to define the
Numbering Plan Identification
Parameter for an ISDN outgoing
call.
0 = System Default
1 = Unknown
2 = ISDN Plan
3 = Data Plan
4 = Telex Plan
5 = National Standard
Plan
6 = Private Plan
(default = 0)
3
44-05-11 ARS/F-Route Table – Network
Specified Parameter Table
Use this program to define the
network specified parameter table
for each F-Route table.
0~16
(default = 0)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
35-02-15 SMDR Output Options – CLI/DID
Number Switching
Determine if the CLI/DID Number
should be displayed.
0 = CLI (CLIP)
1 = DID Calling
Number
(default = 0)
3
35-02-16 SMDR Output Options – Trunk
Name or Received Dialed
Number
Determine how the SMDR should
print incoming calls on ANI/DNIS
or DID trunks. If set to (1), ANI/
DNIS trunks can print DNIS digits,
if set to (0) trunk names are
printed instead.
 For additional SMDR
Services refer to Station
Message Detail Recording
on page 2-977.
0 = Trunk Port
Name
1 = Received
Dialed Number
(default = 0)
3