NEC Univerge SV8100 - Page 691

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 667
General ISDN Programs
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
14-01-13 Basic Trunk Data Setup – Trunk-
to-Trunk Transfer
For each trunk that should be able
to participate in a tandem call, enter
1. To disable a trunk from Tandem
Trunking, enter 0. Required for 2 B-
Channel transfer.
0 = Disable
1 = Enable
(default = 1)
3
15-02-29 Multiline Telephone Basic Data
Setup – PB Back Tone Level
This program option can be used to
adjust the PB Back Tone level when
calling an ISDN line.
1~63 (-15.5dB ~
+15.5dB)
(default = 32) 0db
3
15-07-01 Programmable Function Keys Assign a function key for Caller ID
Block for ISDN (63) if required.
Line Key 1~48
0~99 (Normal Function
Code 751 by default)

00 ~

99
(Appearance Function
Code) (Service Code
752 by default)
3
20-06-01 Class of Service for Extensions Assign a Class of Service to
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
3
20-09-02 Class of Service Options
(Incoming Call Service) – Caller
ID Display
Turns Off (0) or On (1) the Caller ID
display at an extension.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
20-09-03 Class of Service Options
(Incoming Call Service) – Sub
Address Identification
Define whether an extension
displays the Caller Sub-Address, 0
= Deny, 1 = Allow.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-11-11 Class of Service Options (Hold/
Transfer Service) – Auto On-
Hook Transfer
In an extensions Class of Service,
turns Off (0) or On (1) an extension
ability to transfer when the user
hangs up.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-11-14 Class of Service Options (Hold/
Transfer Service) – Trunk-to-
Trunk Transfer Restriction
Turns Off (0) or On (1) the Trunk-to-
Trunk Transfer Restriction. If
enabled, Trunk-to-Trunk Transfer is
not possible.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3
20-11-21 Class of Service Options (Hold/
Transfer Service) – Restriction
for Tandem Trunking on Hang
Up
Allow (0) an extension user’s ability
to set up a tandem call
automatically when they hang up.
0 = Off
1 = On
(default = 0 for
COS 1~15)
3