Issue 1.0 UNIVERGE SV8100
2 - 684 Last Number Redial
Related Features
Automatic Route Selection
Repeat Redial
Save Number Dialed
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3
11-12-12 Service Code Setup (for Service
Access) – Last Number Dial
Assign a service code (#5) to use
Last Number Dial.
MLT, SLT
(default =
#5)
3
11-12-17 Service Code Setup (for Service
Access) – Clear Last Number
Dialing Data
Assign a service code (776) to clear
the Last Number Dial.
MLT, SLT
(default = 776)
3
15-02-13 Multiline Telephone Basic Data
Setup – Redial List Mode
Select the type of numbers that are
stored in the Redial List – Internal
and External numbers (0) or
External only (1).
0 = ICM/Trunk
(Extension/Trunk
Mode)
1 = Trunk Mode
(default = 1)
3
20-08-05 Class of Service Options
(Outgoing Call Service) – Dial
Number Preview (Preset Dial)
Turns Off (0) or On (1) an extension
ability to use Dial Number Preview.
This program also Turns Off or On
the Last Number Redial function.
0 = Off
1 = On
(default = 1 for
COS 1~15)
3
To Next Page
Loading...
