NEC Univerge SV8100 - Page 735

UNIVERGE SV8100 Issue 1.0
SV8100 Features and Specifications Manual 2 - 711
 For additional programming information on Paging, refer to the Paging, External and Paging, Internal features.
Operation
Meet Me External Page
To make a Meet Me External Page:
1. At multiline terminal, press Speaker or pick up the handset.
- OR -
At the single line telephone, lift the handset.
2. Dial 703 and the External Paging Zone code (1~8 or 0 for All Call).
- OR -
Dial 1 and the Combined Paging Zone code 1~8 (for Internal/External Zones 1~8) or 0 (for Internal/
External All Call).
3. Announce the zone.
- OR -
1. At the multiline terminal, press the External Paging Zone key (Program 15-07 or SC 751: 19 +
zone).
2. Announce the zone.
31-02-01 Internal Paging Group
Assignment – Internal Paging
Group Number
Assign extensions to Internal
Paging Groups (i.e., Page Zones).
0~64
(0 = No Setting)
Default: 1
0 for IP Station
1 for TDM Station
3
31-02-02 Internal Paging Group
Assignment – Internal All Call
Paging Receiving
Allow or deny All Call Internal
Paging for each extension. If
allowed, extension can place and
receive All Call Internal Paging
announcements. If prevented,
extensions can only make (not
receive) All Call Internal Paging
announcements. If combined,
Paging zones should be restricted
as well, change the internal page
zone group in Program 31-07-01
to 0.
0 = Off
1 = On
(default = 1)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3