NEC Univerge SV8100 - Page 764

Issue 1.0 UNIVERGE SV8100
2 - 740 Mobile Extension
11-12 Service Code Setup (for Service
Access)
Used to customize the service
codes for Service Access.
Please refer to the
SV8100 Programming
Manual for more
information on this
program.
3
11-13 Service Code Setup (for ACD) Used to customize the service
codes for ACD.
Please refer to the
SV8100 Programming
Manual for more
information on this
program.
3
13-04-01 Speed Dialing Number and Name
– Speed Dialing Data
For the bin number defined in
Program 15-22-01 for the Mobile
Extension, enter the external
number of the Mobile Extension.
This must exactly match the Caller
ID number of the Mobile Extension
or the user cannot access the
internal features.
1~9, 0, , #
Pause (Press line key 1)
Recall/Flash (Press line
key 2)
@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
3
15-22-01 Mobile Extension Setup – Mobile
Extension Target Setup
For each Mobile Extension
number, select the Abbreviated
Dial bin number to be associated
with it.
0~1999
(0 = No setting
1~1999 = target of
mobile extension)
(default = 0)
3
15-22-02 Mobile Extension Setup –
Connect Confirmation
As the Mobile Extension can be a
GSM phone, it is necessary to be
certain a person and not, for
example, a GSM voice mail has
answered the call. This is
achieved by returning Music on
Hold/ring tone to the Mobile
Extension on answer, after which
the Mobile Extension user presses
* to connect the call.
For each Mobile Extension
number, select whether the user
needs to use DTMF confirmation
before a call is answered. Until the
* is pressed, the call is treated as
not being answered.
0 = Always
1 = On analog line
2 = Never
(default = 0)
3
15-22-03 Mobile Extension Setup – Trunk
Access Code
Select if the Normal (0) or
Individual (1) Trunk access is used
when making the call to the mobile
number.
0 = Use normal trunk
access code (Program
11-09-01)
1 = Use individual trunk
access code (Program
11-09-02)
(default = 0)
3
20-03-04 System Options for Single Line
Telephones – Dial Sending Start
Time for SLT or ARS
When an extension user dials a
Mobile Extension number, the
system uses this timer to
determine how long the system
waits before dialing the number.
0~64800 seconds
(default = 1)
3
Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3